Maretron Alarm Module ALM100 Manual do Utilizador descarregar pdf (Página 152)

The min mark is a blue triangle to the right of the cylinder, and is “pushed”

upwards by the top of the liquid. The max mark is a red triangle to the right of the

cylinder and is “pulled” downwards by the top of the liquid. Pressing the Reset

button will move both marks to the current bar position. When the marks are

displayed, the cylinder is made narrower to allow them to fit.

The min and max marks may be enabled and disabled independent of each

other. The Reset button is displayed only if either of the marks is enabled.

9.5.27 Text

Text may be added to a Favorite Screen by using the Text Component. Text is

displayed on one line in a component that is 4 times as wide as it is high. The

text is entered as the title of the component.

An example of the Text component is shown below.

Figure 61 – Text Component Example

9.5.28 Timer

The timer component shows the elapsed time an indicator value has been in a

specified state since the timer was last reset. The elapsed time is in the center of

the component with the date and time of the last reset just below it, the user-

defined title appears at the top of the component, and the units of the parameter

measurement appear in the lower right of the component. A reset button allows

the timer to be reset. Timer components are square in aspect ratio (take the

same number of grids in height as they do in width). An example of a Timer

component is shown below.

Figure 62 –Timer Component Example

Revision 4.0.2 Page 152

1 2 ... 147 148 149 150 151 152 153 154 155 156 157 ... 379 380

Sem comentários

Maretron Alarm Module ALM100 Manual do Utilizador Página 152