Maretron Alarm Module ALM100 Manual do Utilizador descarregar pdf (Página 51)

100

101

h. If you are connecting to an older version you may be asked to request which of

the optional modules for N2KView you wish to use; select the appropriate licenses

that must be checked out from the server.

h. Click “Connect”. The “Connection State:” part of the window will blink

“Connecting…” for a few seconds. It will then either display “Connected” if the

connection was successfully made, or display a message indicating that the

connection was not made and suggesting further action to take.

It will also show details about the connection made.

If the connection is not made, please check the following:

1. Make sure the “Server Password” entered in N2KView matches the “Server

Password” entered into the IPG100; the password in the IPG100 is set from a

DSM250 or N2KAnalyzer. (The USB100 has no password.)

2. If using the WAN mode, make sure the “IP Address/Hostname” of the IPG100 is

reachable from PC running N2KView. (If this is a problem we suggest using

Maretron Cloud Services, or contacting an Internet Technician to help set up your

network with the correct port forwarding.)

Revision 4.0.2 Page 51

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 379 380

Comentários a estes Manuais

Sem comentários

Maretron Alarm Module ALM100 Manual do Utilizador Página 51

Comentários a estes Manuais

Manuais e produtos relacionados com Redes Maretron Alarm Module ALM100